OPINION
 

 

A message from

            Robin Taylor

                       Indupart

                               Managing Director

 

 

WE ALL have a duty to work safely. When it comes to matters of safety, we like to be ahead of the game. From Monday February 23, cable break and spring brake devices became an integral part of every door kit - not an option. This means all new doors will comply with current safety standards that will, in any case, become mandatory from May 2005.

 

This protects your reputation and ours.

 

Training For

Safety And

Success
Training is one of those activities that benefits everyone. It enables fitters to do a better job, more quickly and with greater confidence. The end user has a safer installation that will require less service attention and we can Most courses take place at Stockport where we have a dedicated training suite. However, we can train on client premises where required. Group size varies from two to a maximum of eight, with a typical cost of about 
all bask in the warm glow of a quality job and enhanced reputation.

Mike Deasey demonstrating installation techniques at a recent training session.
 £300 per group, per day - lunch and refreshments included.
Mike Deasey, our senior research and development man has perfected his training techniques over many years. He runs two one day courses for the installation and repair of sectional doors and roller shutter/fire doors. These can be taken as separate days or over two days back to back Instruction combines a little theory with a lot of hands-on practice so that on completion the fitters have really earned their Certificate of Competance. So who benefits? "I have trained everyone from raw recruits to veterans with 20 years experience. Usually trainees have an engineering background but I have also trained joiners and once trained a chef who went on to develop a successful business. Everyone goes away with new expertise that improves their safety, skill and professionalism." Mike concluded.

To book your course or for more information - give Bob a ring on 0161 432 6655.

Door Fitting Made Easy
INDUPART have developed a springless barrel roller shutter that we are convinced is the most fitter friendly on the market. We have also concentrated on maintaining high levels of quality and reliability.

"There was no point in making a door this easy to fit, if you need an electrician to complete the wiring and commissioning." commented Mike Deasey, Indupart's senior research and development engineer, "so we supply the door with a completely pre-wired motor system from Elero, you simply set the limits and plug the motor system into your client's socket."

 
A clever innovation means there are no even polarity problems with the client's phases. The design of the plug enables you to change polarity, simply by removing the plug from the socket and using the screwdriver to turn the phase pins through 180 degrees. There is no need to remove electrical control panels, so you don't need an electrician.

This shutter is unique - you can even change motor handing on-site in minutes, with the minimum of fuss. We have developed this and other products in our range by listening to you the installer, so we can make the product easier to fit.

Sounds too good to be true? We suggest you give it a try.

T:0161 432 6655  F:0161 432 6400  indupart@indupart.co.uk  www.indupart.co.uk