Indupart > Parts > Roller Shutter & Lath Components > Bearings, Sprockets & Components > Roller Shutter Safety Break (Brake)

Catalogue Page: 191

Roller Shutter Safety Break (Brake)

Part Number: 090650

Safety break (brake) device used to replace normal bearings on a roller shutter. Offers protection against roll back when there is a power outage

Material:
Steel
Unit:
Piece (1)
Maximum Bore:
30mm
Maximum Torque:
322Nm
Temperature Range:
-30 – 85°C
Protection Rating:
IP65

This part is for trade members only.

If you are an existing trade member please sign in here.

If you’d like to become a trade member please click here.

Categories: Bearings, Sprockets & Components, Roller Shutter & Lath Components

Other Parts In This Category

18 Tooth Sprocket *SPECIAL ORDER ONLY*

12 Tooth Pinion – 5DP

Square End Plate

18swg 76mm (3″) Solid Lath

Steel Angle – Large

Extra Deep Black Rubber Bottom Seal

Small Centre Lock

Spacer Collar

Steel Angle

20/22swg 76mm (3”) Solid Lath

Bullet Pin Lock with Housing

100mm Wind Guide Channel

Flat Bottom Seal Retainer

Steel Angle

Heavy Duty Bearing

Pressed Pull Handle

Ground Lock Kit for Roller Shutters

Endlocks – Standard Lath

Swipe to see more

Copyright Indupart © 2025 All Rights Reserved. Website Designed by Create8
No portion of this site may be reproduced or redistributed without prior written permission from Indupart.
Terms & Conditions | Privacy Policy